Windows disk map not resolving windows#If using UNC paths is not possible, either disable or remove the Windows Service, then follow the directions in the previous section: The solution in this case is to stop using the mapped network drives letters and instead use UNC paths. When this occurs and the account is elevated, this also ends up creating a new authentication ID and thus previous mapped drives by the non-elevated user are not visible. On Windows Vista, Windows 7, Windows 2008, and later, you may see similar behavior when the User Account Control (UAC) elevates permissions. Any mapped drives created by the same user account is unavailable as they are not mapped during the same log-on session as the service. A service that is configured to run under a specific user account will always create a new log-on session to launch the service. On Windows, normally WebSphere Application Server is created as a Windows Service. WebSphere Application Server as a Windows Service In the example, "wasuser" would need to map drive Z:\ to Įtwork\folder\ in order for that drive to become available.Map the drives so that they are associated with the user account that starts WebSphere Application Server.In the example, the application connects to.Use the Universal Naming Convention (UNC) path in the application to access the shared network location."wasuser" did not map drive Z:\.Įither method can be used to resolve this issue: If any application on the server connects directly to drive Z:\, it isn't found. "wasuser" has permissions to launch WebSphere Application Server from the command line."admin" creates a mapped network drive Z:\ and points it to.WebSphere Application Server is not configured to run as a service. Two user accounts are created, named admin and wasuser. This section also applies to the Liberty Profile. If WebSphere Application Server is set up to run as a nonservice, such as from the command line, the user starting the server (or the user who started the nodeagent) must be the same user who mapped the network drive. WebSphere Application Server as a nonservice Only services owned by the Local System Account can map network drives that can be seen by all other accounts. However, if that same user starts a Windows Service, that service is unable to see the mapped drive. Processes started by this user are able to see this mapped drive. Normal user accounts, including Administrators, can create mapped drives and assign them drive letters ( Z:\) however, they are the only user to see these drives.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |